金属阳离子对煤泥絮团特性及沉降效果的影响机制

    Influence mechanism of metal cation on flocs characteristics and settling effect of coal slurry

    • 摘要: 煤泥水固液分离是制约煤炭清洁生产的瓶颈环节,为明晰金属阳离子对煤泥水沉降效果的影响规律,从煤泥絮团特性角度出发,采用Zeta电位、聚焦光束反射仪(FBRM)、图像分析系统、石英晶体微天平(QCMD)探究了金属阳离子对煤泥沉降速度和上清液浊度的影响机理。结果表明,随着离子价态的升高,煤泥水的沉降速度增大,上清液的透射比增加。高价态金属阳离子可以更好地压缩颗粒表面的双电层,减少静电斥力,促进煤泥颗粒的凝聚。添加Al3+后,煤泥颗粒数量减少的幅度最大,Fe3+、Mg2+、Ca2+次之,Na+、K+颗粒数量减少的幅度最小。金属阳离子对微细颗粒的聚集作用显著,可以一定程度上提高絮团的密实度。高价态金属阳离子与阴离子聚丙烯酰胺APAM复配后煤泥絮团尺寸增大,密度升高,絮团的孔隙及边缘细小分支减少,其中,Al3+与APAM复配下的煤泥絮团尺寸为2.964 mm,絮团密度为1063.69 kg/m3。QCMD结果表明随着离子价态的升高,吸附层的吸附厚度逐渐增加,Fe3+和Al3+在煤泥表面的吸附厚度分别为9.50 nm和9.70 nm。金属阳离子价态越高,煤泥表面金属离子水化吸附层的弹性模量越低,吸附层越稀松,APAM更易穿过稀疏的水化层对煤泥颗粒进行絮凝。同时离子价态越高,金属离子对APAM和煤泥之间的桥联作用越强,促进APAM絮凝煤泥颗粒,形成的絮团尺寸更大且密实,更有利于煤泥的絮凝沉降,该研究可为煤泥水沉降脱水药剂制度的优化提供理论依据。

       

      Abstract: The solid-liquid separation in coal slurry is a bottleneck that restricts coal processing and utilization. To clarify the influence of metal cation on the settling performance of coal slurry, the effect of metal cation on settling velocity and supernatant turbidity is investigated by the settling tests. Then the Zeta potential, focused beam reflectometer (FBRM), image analysis system, and quartz crystal microbalance (QCMD) analysis are conducted from the perspective of the flocs characteristics. The results indicate that as the valence state of metal cation increases, the settling velocity of coal slurry and the transmittance of the supernatant both increases. High valence metal cations can better compress the double layer on the surface of particles, reduce electrostatic repulsion, and promote the agglomeration of coal slurry particles. The reduction in the number of coal slurry particles is the largest after adding Al3+, followed by Fe3+, Mg2+, and Ca2+, while the reduction in the number of Na+ and K+ is the smallest. The aggregation effect of metal cation on fine particles is significant, which can improve the compactness of flocs. When high valence metal cations are combined with APAM, the size and density of coal slurry flocs increase, and the pores and small branches at the edges of the flocs decrease. When Al3+ is combined with APAM, the size of coal slurry flocs is 2.964 mm and the floc density is 1063.69 kg/m3. The QCMD results reveal that as the ion valence state increases, the thickness of the adsorption layer gradually increases. The adsorption thickness of Fe3+and Al3+on the coal surface is 9.50 nm and 9.70 nm, respectively. The higher the valence state of metal cation, the lower the elastic modulus adsorbed on the coal surface and the looser the adsorption layer. Therefore, APAM is more likely to pass through the adsorption layer and flocculate coal particles through hydrogen bonding. In addition, the looser the structure of the adsorption layer, it is easier to bind with APAM through electrostatic interactions. Moreover, their larger and denser flocs are more conducive to the flocculation and settling of coal slurry. This study can provide theoretical basis for the agent system optimization of coal slurry settling and dewatering.

       

    /

    返回文章
    返回